วางแผนสถาปัตยกรรมตั้งแต่ต้นทางถึงปลายทาง

You are about to build a real smart-home sensor: it reads the room, sends data to the cloud, and you can update it wirelessly. Let's plan it first. 🚀

A good architecture sketch saves hours of rewiring and rewriting. You decide what each part does before you touch a single wire.

Most IoT projects share four layers: the sensors, the board that reads them, the network, and the cloud that stores and shows the data.

Start with what you want to know. Here a DHT sensor reads temperature and humidity, the raw signal your whole project is built around.

An ESP32 is your brain here: it reads the sensor and has built-in WiFi, so one chip handles sensing and connecting to the network.

The board joins your WiFi and speaks MQTT, a tiny messaging protocol perfect for sending small readings often without wasting power.

A cloud dashboard receives your messages, stores the history, and draws charts so you can watch the room from anywhere.

Picture one arrow per hop: sensor → board → WiFi → cloud → your phone. If you can draw it, you can build it.

Before wiring, write a quick bill of materials: ESP32, DHT22, a pull-up resistor, jumper wires, and a USB cable to flash the first sketch.

Because the device will live on a shelf, plan for OTA updates from day one so you never need to unplug it to fix a bug.

Decide topic names now, like home/livingroom/temp. Clear names keep the cloud side simple when you publish and subscribe later.

Time to test your plan.

You mapped four layers, sketched the data flow, listed your parts, and named your topics. With a clear plan, building the node comes next. 🧭